Camaro / Firebird Cover - PCM
Clean up that mess of wires with our PCM cover. Made of polished or brushed stainless steel. Simple installation, just peel the back off the included 3M Dual Lock fasteners and place cover on PCM.
PCM Cover - Polished Finish on 99 TA
Posted by cb on 5th Oct 2017
Nice quality and good looking finish. The protective film prevented considerable scratching that would have occurred during test fitting. Had to do a few minor mods to get it to fit: 1) Cut a small factory zip tie at the top/driver side of the PCM in order to push wires back and down below top surface of PCM. 2) Wrap a new zip tie around the pair of wire harnesses that extend from PCM toward the driver side in order to lower the upper harness a bit. 3) Bend the PCM cover "tab" upward a bit to clear the wire harness that was lowered in previous step.
Posted by John B on 6th Apr 2015
Had mine powder coated in Kingsport grey to match graphics on the body of my car. Not flashy like chrome, but settle and subdued. Steve did an excellent job and sent me all pictures I asked for before I made my purchase.
Customers also viewed